Canon Camera Lens 22mm F 2 User Manual

CT1-8584-000  
1. Mounting and Detaching the Lens  
Please mount and detach the lens only with the  
camera turned OFF.  
See your camera’s instructions for details on  
mounting and detaching the lens.  
Handling Cautions  
ENG  
EF-M LENS Instructions  
If the lens is taken from a cold environment  
into a warm one, condensation may develop  
on the lens surface and internal parts. To  
prevent condensation in this case, first put the  
lens into an airtight plastic bag before taking it  
from a cold to warm environment. Then take  
out the lens after it has warmed gradually. Do  
the same when taking the lens from a warm  
environment into a cold one.  
EF-M22mm f/2 STM  
After detaching the lens, place the lens with  
the rear end up to prevent the lens surface and  
contacts from getting scratched. (fig.)  
If the contacts get soiled, scratched, or have  
fingerprints on them, corrosion or faulty  
connections can result. The camera and lens  
may not operate properly.  
Do not leave the lens in excessive heat such as  
in a car in direct sunlight. High temperatures  
can cause the lens to malfunction.  
Please also refer to the handling cautions found  
in your camera’s instructions.  
If the contacts get soiled or have fingerprints on  
them, clean them with a soft cloth.  
If you remove the lens, cover it with the dust  
cap. To attach it properly, align the lens mount  
index and the index of the dust cap as shown  
in the diagram, and turn clockwise. (fig.) To  
remove it, reverse the order.  
Conventions used in this instruction  
Warning to prevent lens or camera  
malfunction or damage.  
Supplementary notes on using the lens and  
taking pictures.  
2. Manual Fcus  
When tcama’s focus mode is set to [MF], focus  
manually ng the focusing ring (fig.).  
Nomenclature  
Focusing ring  
Hood/Filter Mounting Thread  
Lens mount index  
Contacts  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions: (1)  
This device may not cause harmful interference, and  
(2) this device must accept any interference received,  
including interference that may cause undesired  
operation.  
Do not make any changes or modifications to  
the equipment unless otherwise spein th
instructions. If such changes or mifications sh
be made, you could be required ttop operation o
the equipment.  
This equipment has been tested and und to mply  
with the limits for a class B digital devicuant  
to part 15 of the FCC Rules. These limits are  
designed to provide reasonable protection against  
harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications.  
However, there is no guarantee that interference will  
not occur in a particular installation. If this equipment  
does cause harmful interference to radio or television  
reception, which can be determined by turning the  
equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the  
following measures:  
ckly rotag the focusing ring may result in  
yed focus
Thank you for purchasing a Canon product.  
The Canon EF-M22mm f/2 STM lens is a small fixed  
focus length lens developed for interchangeable-lens  
digital cameras compatible with EF-M lenses*.  
Focus mode is set using the camera. Please  
efer to the camera’s instructions.  
fter autofocusing in [AF+MF] mode, focus  
manually by pressing the shutter button halfway  
and turning the focusing ring (full-time manual  
focusing).  
* Only the following cameras are compatible with  
EF-M lenses (as of July 2012):  
EOS M  
"STM" stands for stepping motor.  
Safety Precautions  
Do not look at the sun or a bright light source  
through the lens. Doing so could result in vision  
loss or blindness.  
Whether it is attached to the camera or not, do  
not leave the lens under the sun without the  
lens cap attached. This is to prevent the lens  
from concentrating the sun’s rays, which could  
cause a fire.  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment  
and receiver.  
Consult the dealer or an experienced radio/TV  
technician for help.  
This Class B digital apparatus complies with  
Canadian ICES-003.  
ENG-1  
 

Belkin Network Router F5D6231AU4 User Manual
Black Box Network Hardware Hardened Ethernet Extender User Manual
Blue Rhino Charcoal Grill NB1854WRTR User Manual
Bookendz Laptop Docking Station BE 10281 User Manual
Bosch Appliances Cooktop PGP976SET User Manual
Bowers Wilkins Speaker CCM7 User Manual
Briggs Stratton Trash Compactor 205378GS User Manual
Califone Digital Camera DC596 User Manual
Canon Welding System CR DA1 User Manual
Casio Watch QW 1441 User Manual